pv magazine test: January 2023 Results
By George Touloupas
This article was originally published in pv magazine – March 2023 edition. Learn more about the pv magazine test here.
CEA’s Senior Director of Technology & Quality, George Touloupas, provides analysis of the January 2023 energy yield results from the outdoor test field in Xi’an, China.
The first chart below (Figure 1) shows the meteo station data (irradiance and ambient temperature) for January 2023.
Figure 1: Daily temperature and irradiance data - January 2023
Figures 2 and 3 below show the relative specific energy yield comparison between different PV module technologies. A new Tongwei bifacial PERC product has been installed, although the top performer is still Longi’s bifacial PERC module, the average specific energy yield of the bifacial TOPCon category leads over the average specific energy yield of modules in the bifacial PERC category.
Figure 2: Relative yield of different technologies - January 2023
Figure 3: Total energy yield - January 2023
Our test field currently only has one sample from Jolywood in the n-TOPCon bifacial category. As TOPCon modules become more prominent, we look forward to installing more samples of this type to achieve a more representative yield comparison.
The average bifacial boost is 6.73% for January. Bifacial boost is defined as the relative advantage of the average specific energy yield of all bifacial products compared to the average specific energy yield of all mono-facial mono PERC products. [Read: LCOE of Monofacial vs Bifacial Modules: Are Bifacials Worth the Extra Cost?]
Table 1: Bifacial boost - October 2022 to January 2023
Notes on the energy yield measurements:
The energy yield comparison among various technologies, including bifacial boost, will be analyzed using products installed after the beginning of 2019.
The energy yield is given in Wh/Wp and calculated by dividing the energy produced by the module by the Pmax at STC of the module. This Pmax is the maximum STC power after a process of stabilization.
The results are grouped in categories, per module type.
The bifacial boost depends on many parameters: the bifaciality factor, the installation geometry, the albedo of the ground, and the sun angle and diffuse irradiance. The ground in this case is gray gravel.
Table 2: Energy yield ranking - historical - October 2022 to January 2023
Test Cooperation
pv magazine test is a cooperative effort involving pv magazine, APsystems, CEA, and Gsolar. All testing procedures are carried out at Gsolar’s test laboratory in Xi’an, China. CEA supervises these tests and designed both the indoor and outdoor testing procedures.